Pattern Engineering

Sep 17, 20213 min read

How to standardize number of garments on a marker as per order Quantity?

Fabric consumption depends greatly on the amount of clothes on a marker because the more the amount of garment patterns on a marker the...

Jul 7, 20212 min read

LEARN TWO-DART FRONT & BACK WAIST SLOPER WITH SHOULDER DART

DEVELOPING FRONT WAIST FIGUREV1 A. Cut paper approximately 24'' (60.96-cm)square. B. Fold paper in half, crease sharply and pin work...

Apr 9, 20213 min read

HOW TO TAKE MEASUREMENT ON DRESS FORM FOR DRAFTING FRONT WAIST SLOPER?

Slopers differ from one garment manufacturer to another, and often within the manufacturer. The differences occur because all firms do...

Apr 9, 20211 min read

HOW TO TAKE MEASUREMENT ON BODY &ARM FORM FOR DRAFTING SLEEVE SLOPER?

NOTE:- If measuring on arm of dress form, follow the same procedure allowing the same amount of ease. CAP HEIGHT Tie tape measure or tape...

Mar 4, 20212 min read

What Factors affecting good fit and Reasons for poor fitting?

Factors affecting good fit and causes for poor fitting The goal of any pattern alteration is to form the pattern fit better, but before...

Jan 8, 20213 min read

What is standards for good fit ?

There are Five standards for good fit – Ease, line, set, balance and grain 1.Ease Ease is the distinction between the circumference...

Jan 8, 20213 min read

How To Prepare of garment for fitting?

Preparation of garment for fitting All facings should be in position except those at hem of a jacket/sleeve. Seams which are unlikely to...

Jan 7, 20212 min read

What Are The Terms relating to fit?

Strain: Strain: Strain: Strain is characterized by means of moderate folds that commence and cease inside the clothes outline, such as...

Blog